ISO 4310-301-00-I Stainless steels
Data updates
This material has 1108 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ISO 4310-301-00-I Chemical Composition
ISO 15510: 2014 / Stainless steels -- Chemical composition
Looking for full material performance data?
Free registration required • Instant access
ISO 4310-301-00-I Physical Properties
Temperature
This material has 1108 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ISO 4310-301-00-I Heat Treatments
- Heat treated at 250-425°C; Duration: 30 min to 4h; Air cooling; The optimum heat treatment conditions may be very different. The spring manufacturer shall choose those conditions answering the purpose; The heat treatment data refer to compression springs, torsion and tension (springs without initial tension); The lower temperature is recommended for extension springs with prestress.
- Hot forming: 1150-850°C, air cooling; Solution annealing (+AT): 1010-1090°C, water or air rapid cooling. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1000°C for steels with Mo contents up to 3%, and a temperature of 1020°C for steels with Mo contents exceeding 3%.
ISO 4310-301-00-I Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ISO 4310-301-00-I International Equivalent Materials
Showing 15 of 477 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 477 international equivalents?
See all 477 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 477Cross References
- 65Composition
- 126Mechanical Properties
- 10Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- 4Formability
- 6Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 38Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 377Total Suppliers