ASTM F 594 416Se Stainless steels
Data updates
This material has 53 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM F 594 416Se Chemical Composition
F594: 2024 / Standard Specification for Stainless Steel Nuts
Looking for full material performance data?
Free registration required • Instant access
ASTM F 594 416Se Physical Properties
Temperature
This material has 53 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM F 594 416Se Heat Treatments
- Condition H: When condition H is specified the martensitic alloys shall be hardened and tempered by heating to 1010 +/- 28°C sufficient for austenitization, held for at least 1/2h and rapid air or oil quenched then reheating to 565°C minimum for at least 1h and air cooled to provide the specific properties
Condition HT: When condition HT is specified the martensitic alloys shall be hardened and tempered by heating to 1010 +/- 28°C sufficient for austenitization, held for at least 1/2h and rapid air or oil quenched then reheating to 274°C minimum for at least 1h and air cooled to provide the specific properties.
ASTM F 594 416Se Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM F 594 416Se International Equivalent Materials
Showing 15 of 32 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 32 international equivalents?
See all 32 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 32Cross References
- 7Composition
- 4Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 5Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 1Total Suppliers