ISO X12CrNiSi18-9-3 Stainless steels
Data updates
This material has 143 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ISO X12CrNiSi18-9-3 Chemical Composition
ISO 16143-1: 2014 / Stainless steels for general purposes - Part 1: Corrosion-resistant flat products
Looking for full material performance data?
Free registration required • Instant access
ISO X12CrNiSi18-9-3 Physical Properties
Temperature
This material has 143 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ISO X12CrNiSi18-9-3 Heat Treatments
- Hot forming: 1150-850°C, air cooling; Solution annealing (+AT): 1010-1150°C, water or air rapid cooling. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1000°C for steels with Mo contents up to 3%, and a temperature of 1020°C for steels with Mo contents exceeding 3%.
ISO X12CrNiSi18-9-3 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ISO X12CrNiSi18-9-3 International Equivalent Materials
Showing 15 of 102 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 102 international equivalents?
See all 102 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 102Cross References
- 14Composition
- 9Mechanical Properties
- 4Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- 2Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 11Total Suppliers