AS JN/HBW600XCr35 Cast irons
Data updates
This material has 14 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
AS JN/HBW600XCr35 Chemical Composition
AS 2027: 2007 / Abrasive-resistant cast irons
Looking for full material performance data?
Free registration required • Instant access
AS JN/HBW600XCr35 Heat Treatments
- Typical heat treatments are hardening, tempering, soft annealing and annealing. A typical hardening cycle is: slowly heating up to a temperature within the range of 900°C to 1050°C, holding for a determined period of time, then rapidly cooling. A typical tempering cycle involves: slowly heating up to a temperature within the range of 200°C to 550°C, holding for a period of time appropriate to the thickness, followed by air or furnace cooling. Annealing method is: slowly heating up to a temperature within the range of 920°C to 975°C, holding for at least 1 h, then slowly cooling down in the furnace to about 810°C and then further cooling down to 600°C at a rate not exceeding 55 K/h, followed by air or furnace cooling. If castings require annealing then a typical annealing involves slowly heating up to a temperature of 700°C to 750°C for a minimum of 4 h, and then slowly cooling in the furnace to 600°C, following by air or furnace cooling.
AS JN/HBW600XCr35 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
AS JN/HBW600XCr35 International Equivalent Materials
Showing 2 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 9Composition
- 1Mechanical Properties
- -Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers