PROPRIETARY 11R51 Stainless steels
Data updates
This material has 541 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 11R51 Chemical Composition
Sandvik Materials Technology, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY 11R51 Physical Properties
Temperature
This material has 541 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY 11R51 Heat Treatments
- Tempered at 425°C for 4h. Springs tempering at 425°C (780°F)/0.5 - 4 h. In continuous conveyor furnaces, where the holding time at temperature is very short (min. 3 minutes), the temperature can be increased to about 475° (780°F). Batch tempering at 250°C (480°F)/0.5–3 h, or continuous tempering in a conveyor furnace with a holding time of 3–5 minutes at about 300°C (570°F).
- The strength can be increased by a tempering operation at 425°C (797°F) for 4 hours. An increase in tensile strength of approx. 100 to 250 MPa can be expected, depending on the initial cold rolled tensile strength.
To avoid discoloration, parts should be carefully cleaned before heat treatment.
Tempering in open air furnaces gives a harmless brownish oxide on the surface.
PROPRIETARY 11R51 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY 11R51 International Equivalent Materials
Showing 15 of 213 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 213 international equivalents?
See all 213 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 213Cross References
- 16Composition
- 64Mechanical Properties
- 54Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- 2Formability
- 12Fatigue
- -Fracture
- -Creep
- 2Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 174Total Suppliers