MIL ORD4150 Structural and constructional steels
Data updates
This material has 17 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MIL ORD4150 Chemical Composition
MIL-B-11595E: 2004 / Bar, Metal and Blanks, Steel (Under 2 Inches in Diameter) for Barrels of Small Arms Weapons
Looking for full material performance data?
Free registration required • Instant access
MIL ORD4150 Physical Properties
Temperature
This material has 17 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MIL ORD4150 Heat Treatments
- Austenitizing temperature: 1575 ± 25°F (857°C ± 4°C); Approximate tempering: 1150ºF (621°C). Minimum holding time for each heat treating operation should be 1 hour at heat for each inch of thickness at the maximum effective cross-section; Stress relief: Unless otherwise specified, material which has been cold straightened after heat-treatment shall be stress relieved at a temperature not lower than 150ºF (65°C) below the final tempering temperature.
MIL ORD4150 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- -Cross References
- 7Composition
- 6Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers