PROPRIETARY Uddeholm Carmo Tool steels
Data updates
This material has 34 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Carmo Chemical Composition
Böhler-Uddeholm AG, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Uddeholm Carmo Physical Properties
Temperature
This material has 34 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Carmo Heat Treatments
- Stress relieving at 550–650°C (1020–1200°F). Holding time: 2h. Cooling in furnace to 500°C (930°F), then in air.
Hardening:
- Pre-heating temperature: 600–700°C (1110–1290°F).
- Austenitizing temperature: 950–970°C (1740–1780°F), normally 960°C (1760°F). Holding time: 30–45 minutes.
Quenching:- Forced air/gas.
- Vacuum furnace with sufficient overpressure.
- Martempering bath or fluidized bed at 200–550°C (320–1020°F) followed by forced air cooling.
- Oil.
Quenching in oil gives an increased risk for dimensional changes and cracks. Temper the tool as soon as its temperature reaches 50–70°C (120–160°F).
Tempering: Temper twice. Lowest tempering temperature 200°C (390°F). Holding time at temperature minimum 2 hours. - Austenitizing temperature 950°C (1760°F). Holding time 30 minutes
PROPRIETARY Uddeholm Carmo Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Uddeholm Carmo International Equivalent Materials
Showing 1 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 6Composition
- 5Mechanical Properties
- 12Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers