PROPRIETARY BÖHLER W100 Tool steels
Data updates
This material has 171 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER W100 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER W100 Physical Properties
Temperature
This material has 171 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER W100 Heat Treatments
- Annealing: 750 to 800°C / Controlled slow cooling in furnace (10 to 20°C/h) to approx. 600°C air cooling.
Stress relieving: 600 to 650°C, slow cooling in furnace. Slow cooling in furnace; intended to relieve stresses set up by extensive machining, or in complex shapes. After through heating, hold in neutral atmosphere for 1 to 2 hours.
Hardening: 1070 to 1150°C, oil, salt bath (500 to 550°C), air. Holding time af temperature equalization: 15 to 30 minutes.
Tempering: Slow heating to tempering temperature immediately after hardening/time in furnace: 1 hour for every 20 mm of work piece thickness, but not less than 2 hours/ air cooling (minimum holding time: 1 hour):;
1st tempering tempering approx. 30°C above maximum secondary hardness
2nd tempering to desired working hardness
3rd tempering for stress relieving. 30 - 50°C below highest tempering temperature
PROPRIETARY BÖHLER W100 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER W100 International Equivalent Materials
Showing 15 of 73 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 73 international equivalents?
See all 73 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 73Cross References
- 6Composition
- 7Mechanical Properties
- 28Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 56Total Suppliers