PROPRIETARY Hiperco 50 Magnetic and electrical materials
Data updates
This material has 61 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Hiperco 50 Chemical Composition
Carpenter Technology Corporation, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Hiperco 50 Physical Properties
Temperature
This material has 61 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Hiperco 50 Heat Treatments
- A dry hydrogen atmosphere or high vacuum is recommended to minimize oxide contamination during annealing. When hydrogen is employed and the inside retort temperature is above 482°C (900°F), the entry dew point should be dryer than -51°C (-60°F) and the exit dew point should be dryer than about -40°C (-40°F).
Anneal parts at 704-871°C (1300-1600°F) for 2-4 hours in dry hydrogen or vacuum and cool at 139-222°C/h (250-400°F)/h until 316°C (600°F) is reached, after which any cooling rate can be employed.
The exact heat treat temperature used will depend on the particular application and the desired compromise between magnetic and mechanical properties. Increasing temperature within the range of 704-871°C (1300-1600°F) will result in improved magnetic properties and decreased yield and tensile strengths. However, the temperature should never exceed 871°C (1600°F), as soft magnetic characteristics will start to decline due to formation of an austenitic phase.
PROPRIETARY Hiperco 50 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Hiperco 50 International Equivalent Materials
Showing 3 of 5 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 5 international equivalents?
See all 5 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 5Cross References
- 5Composition
- 20Mechanical Properties
- 19Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 6Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 5Total Suppliers