PROPRIETARY Carpenter Stainless Type 440C Stainless steels
Data updates
This material has 178 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Carpenter Stainless Type 440C Chemical Composition
Carpenter Technology Corporation, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Carpenter Stainless Type 440C Physical Properties
Temperature
This material has 178 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Carpenter Stainless Type 440C Heat Treatments
- Annealing: for maximum softness, this steel should be heated uniformly to 843/871°C (1550/1600°F). Soak and cool very slowly in the furnace. Brinell hardness approximately 223. Intermediate or process annealing treatment - heat uniformly to 732/760°C (1350/1400°F). Air cool. Brinell hardness about 255.
Hardening: heat to 1010/1066°C (1850/1950°F); soak; quench in warm oil or cool in air. Do not overheat. When overheated, full hardness cannot be obtained.
Tempering: hardness of approximately Rockwell C 60 will be obtained. To remove peak stresses and yet retain maximum hardness, temper at least one hour at 149/177°C (300/350°F).
PROPRIETARY Carpenter Stainless Type 440C Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Carpenter Stainless Type 440C International Equivalent Materials
Showing 3 of 131 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 131 international equivalents?
See all 131 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 131Cross References
- 8Composition
- 11Mechanical Properties
- 10Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- 6Tribology
- 6Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers