ISO X 2 CrNiMo 17 13 Stainless steels
Data updates
This material has 550 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ISO X 2 CrNiMo 17 13 Chemical Composition
ISO 9329-4: 1997 / Seamless steel tubes for pressure purposes - Technical delivery conditions - Part 4: Austenitic stainless steels
Looking for full material performance data?
Free registration required • Instant access
ISO X 2 CrNiMo 17 13 Physical Properties
Temperature
This material has 550 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ISO X 2 CrNiMo 17 13 Heat Treatments
- Quenching: 1020-1120°C, water quench or air cool if sufficiently rapid.
- Solutionized at 1020-1120°C, water quenched or air cooled
In the case of heat treatment in continuous furnaces, the temperature of the furnace atmosphere should normally be in the upper part of the given temperature range or even exceed it
In the case of heat treatment during processing after delivery, the lower part of the given solution temperature ranged is to be aimed for. If during hot working, the temperature was not below the specified lower limit of the solution temperature, 1000°C is sufficient for repeat heat treatments
ISO X 2 CrNiMo 17 13 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ISO X 2 CrNiMo 17 13 International Equivalent Materials
Showing 15 of 240 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 240 international equivalents?
See all 240 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 240Cross References
- 32Composition
- 102Mechanical Properties
- 3Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 16Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 153Total Suppliers