ASTM A 356 Grade 10 Cast steels
Data updates
This material has 20 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 356 Grade 10 Chemical Composition
A356/A356M: 2021 / Steel Castings, Carbon, Low Alloy, and Stainless Steel, Heavy-Walled for Steam Turbines
Looking for full material performance data?
Free registration required • Instant access
ASTM A 356 Grade 10 Heat Treatments
- Heat treatment for mechanical properties:
Normalizing: The castings shall be heated to and held at the proper temperature for a sufficient time to effect the desired transformation and withdrawn from the furnace and allowed to cool to effect complete transformation.
Tempering: The casting shall be heated to and held at the proper temperature, which shall be below the transformation range, and then cooled under suitable conditions. The tempering temperature shall not be less than 595°C (1100°F).
Stress relieving: The stress relieving operation shall be carried out in the same manner as tempering. The temperature shall be within 28°C (50°F), but not exceeding the final tempering temperature.
Minimum preheat temperature: 200°C (400°F) for t > 13 mm, 150°C (300°F) for t ≤ 13 mm.
ASTM A 356 Grade 10 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 356 Grade 10 International Equivalent Materials
Showing 1 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 7Composition
- 4Mechanical Properties
- -Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 4Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers