ASTM A 278 Class 350 Cast irons
Data updates
This material has 139 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 278 Class 350 Chemical Composition
A278/A278M: 2001 / Standard Specification for Gray Iron Castings for Pressure-Containing Parts for Temperatures Up to 650°F (350°C)
Looking for full material performance data?
Free registration required • Instant access
ASTM A 278 Class 350 Heat Treatments
- Castings intended for use above 230°C (450°F): stress-relieved in a suitable furnace at a temperature not exceeding 205°C (400°F), heating uniformly to 565 - 650°C (1050 -1200°F), minimum 2 h, maximum 12 h. The heating and cooling rates shall be uniform and shall not be more than 222°C/h (400°F/h) for castings of 25 mm max. section. For heavier sections the maximum heating and cooling rates in C°/h shall be 205 divided by the maximum section thickness.
Castings intended for use bellow 230°C (450 °F): either heat treatment as above specified either cooled in the mold to 250°C (480°F) at an average rate of not more than 50°C/h (90°F/h) for castings up to 25 mm in section; For heavier sections the maximum cooling rate in degrees C°/h shall be 1250 divided by the maximum section thickness.
ASTM A 278 Class 350 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 278 Class 350 International Equivalent Materials
Showing 15 of 94 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 94 international equivalents?
See all 94 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 94Cross References
- 3Composition
- 1Mechanical Properties
- -Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 40Total Suppliers