SAE 5337 Structural and constructional steels
Data updates
This material has 27 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE 5337 Chemical Composition
SAE AMS 5337E: 2017 / Steel, Maraging, Investment Castings 18.5Ni - 9.0Co - 5.0Mo - 0.70Ti - 0.12Al Vacuum Melted, Homogenized, Overaged, and Solution Heat Treated
Looking for full material performance data?
Free registration required • Instant access
SAE 5337 Physical Properties
Temperature
This material has 27 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE 5337 Heat Treatments
- Production Castings and Specimens:
Homogenized, Overaged, Solution heat treated and Maraged:
Homogenization: Heat to 1149 ± 14°C (2100 ± 25°F), hold at heat for 4 ± 0.25 hour, and cool to room temperature at a rate equivalent to air cool or faster;
Overaging: Heat to 593 ± 14°C (1100 ± 25°F), hold at heat for 1 to 4 hours, and cool to room temperature at a rate equivalent to air cool or faster. Alternately, heat to the solution heat treating temperature directly after overaging without cooling between steps;
Solution heat treated: Heat to 816 ± 14°C (1500 ± 25°F), hold at heat for 1 hour per 25 mm of section thickness but in no case less than 1 hour, and cool to room temperature at a rate equivalent to air cool or faster;
Maraged: Heat to 482 ± 8°C (900 ± 15°F), hold at heat for 3 ± 0.25 hours, and cool to room temperature at a rate equivalent to air cool or faster
SAE 5337 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE 5337 International Equivalent Materials
Showing 1 of 7 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 7 international equivalents?
See all 7 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 7Cross References
- 10Composition
- 6Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers