ASME SA-250 Grade T12 Structural and constructional steels
Data updates
This material has 164 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SA-250 Grade T12 Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part A Ferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SA-250 Grade T12 Physical Properties
Temperature
This material has 164 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SA-250 Grade T12 Heat Treatments
- After welding, or when cold finished, after the final cold-drawing pass, all tubes shall be heat treated and supplied in the full annealed, isothermal annealed, normalized or normalized and tempered condition at the option of the manufacturer. If furnished in the normalized and tempered condition, the minimum tempering temperature shall be 650°C (1200°F).
ASME SA-250 Grade T12 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SA-250 Grade T12 International Equivalent Materials
Showing 2 of 15 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 15 international equivalents?
See all 15 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 15Cross References
- 7Composition
- 5Mechanical Properties
- 83Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- 44Creep
- -Joints
- -Coatings
- 7Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 1Total Suppliers