ASME SA-369 FP5 Structural and constructional steels
Data updates
This material has 686 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SA-369 FP5 Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part A Ferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SA-369 FP5 Physical Properties
Temperature
This material has 686 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SA-369 FP5 Heat Treatments
- Pipe shall be reheated and furnished in the full-annealed or normalized and tempered condition. If furnished in the normalized and tempered condition, the temperature for tempering shall be 680°C (1250°F) or higher.
It is recommended that the temperature for tempering should be at least 50°C (100°F) above the intended service temperature; consequently, the purchaser should advise the manufacturer if the service temperature is to be over 600°C (1100°F).
ASME SA-369 FP5 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SA-369 FP5 International Equivalent Materials
Showing 12 of 58 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 58 international equivalents?
See all 58 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 58Cross References
- 7Composition
- 41Mechanical Properties
- 54Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- 59Creep
- -Joints
- -Coatings
- 16Dimensions
- -Tribology
- 441Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 6Total Suppliers