UNI 36 CrMn 4 Structural and constructional steels
Data updates
This material has 118 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI 36 CrMn 4 Chemical Composition
UNI 7847: 1979 / Hot rolled, unalloyed and alloyed special steel products, bars and coils, for surface hardening. Qualities, requirements and tests
Looking for full material performance data?
Free registration required • Instant access
UNI 36 CrMn 4 Physical Properties
Temperature
This material has 118 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI 36 CrMn 4 Heat Treatments
- Material is normally supplied in the hot rolled condition but, subject to agreement, may be supplied in one of the following conditions: Soft Annealed (SA) to a maximum hardness by annealing at 680 - 720°C. Spheroidise Annealed (Spheroidised). Annealed to obtain a ferritic/pearlite structure (Annealed). Hardened and Tempered (H+T). The H+T values shown in the mechanical properties table are obtained from a test piece hardened by oil quenching from 840 - 860°C followed by tempering at 550 - 650°C for at least 1 hour. The temperature of the oil must be between 15 - 60°C. The Rockwell C Scale hardness minimum value (Heat Treated condition) shown in the mechanical properties table is the surface hardness which must be obtained whether material is in the normalised condition and subsequently surface hardened or whether the material is in the hardened and tempered condition and subsequently surface hardened; Both treatments are followed by tempering at 140-180°C for approximately 1 hour. The specification gives a normalising treatment of 860 - 890°C.
UNI 36 CrMn 4 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI 36 CrMn 4 International Equivalent Materials
Showing 15 of 54 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 54 international equivalents?
See all 54 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 54Cross References
- 6Composition
- 8Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 46Total Suppliers