UNI 18 NiCrMo 5 Structural and constructional steels
Data updates
This material has 291 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI 18 NiCrMo 5 Chemical Composition
UNI 7846: 1978 / Finished products in hot rolled unalloyed or special hardening alloyed steel bars and rolls. Quality, requirements and tests
Looking for full material performance data?
Free registration required • Instant access
UNI 18 NiCrMo 5 Physical Properties
Temperature
This material has 291 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI 18 NiCrMo 5 Heat Treatments
- Hot worked at 1100-900°C; Cementation at 870-900°C; Core hardened at 840-870°C; Surface hardened at 800-830°C. Quenched in hot water bath; Stress relieved at 150-200°C.
- Material is normally supplied in the hot rolled condition but subject to agreement may be supplied in one of the following conditions: Soft Annealed (SA). Spheroidise Annealed (Spheroidised). Annealed to obtained a lamellar ferrite and pearlite structure (Annealed). The H + T values shown in the mechanical properties table are obtained from an 11mm test bar hardened by oil quenching from 850°C +/- 10°C after holding at temperature for at least 30 minutes, and tempered at 180°C +/- 10°C for at least 1 hour. Final Heat Treatment: Case harden at 870 - 900°C. Harden the core by oil quenching from 840 - 870°C. Harden the case by oil quenching from 800 - 830°C. Finally, temper at 150 - 200°C.
UNI 18 NiCrMo 5 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI 18 NiCrMo 5 International Equivalent Materials
Showing 15 of 99 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 99 international equivalents?
See all 99 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 99Cross References
- 28Composition
- 39Mechanical Properties
- 10Physical Properties
- 6Heat Treatment
- -Metallography
- -Machinability
- 5Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 104Total Suppliers