CSN 19 830 Tool steels
Data updates
This material has 109 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
CSN 19 830 Chemical Composition
CSN 41 9830: 1966 / High speed steel 19 830
Looking for full material performance data?
Free registration required • Instant access
CSN 19 830 Physical Properties
Temperature
This material has 109 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
CSN 19 830 Heat Treatments
- Forging at 1100 to 900°C, slowly cooling, eg in dry ash or oven.
Soft annealing at 800 to 840°C, 4 to 8 hours to warm up and slowly cool in the oven.
Annealing to reduce stress at 700 to 750°C, 1 to 2 hours to warm up and slowly cool in the oven.
Hardening:
a) at 1220 to 1250°C, for rough-form roughing tools.
b) at 1190 to 1220°C, for sophisticated tools, fine edge tools, finishing tools.
Cooling in a salt bath at a temperature of 500 to 550°C or in oil, in air or in the air stream.
Tempering:
a) at 550 to 560°C, at least twice for 1/2 to 2 hours.
b) at 540 to 550°C, the last tempering temperature is selected by about 10°C lower than at the first tempering. After tempering, cool in the air. For possible nitriding, a temperature of about 10 to 20°C is chosen to be lower than the last tempering temperature.
CSN 19 830 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
CSN 19 830 International Equivalent Materials
Showing 15 of 49 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 49 international equivalents?
See all 49 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 49Cross References
- 9Composition
- 2Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 45Total Suppliers